American Bass TITAN 10 Package | 10" 1600W D4 Subwoofer & Orion XTR1000.1D Amplifier

Sub & Amp Package Deal

(1) American Bass TITAN 10 Inch 1600W DVC 4 Ohm Subwoofer | TITAN-1044

(1) Orion XTR 1000W RMS Monoblock Subwoofer Amplifier | XTR1000.1D 

*This setup is intended to run at 2 Ohms

Introducing the American Bass Titan subwoofer: the subwoofers that hits hard without hitting your wallet. If you're an audiophile looking to bump your car audio system up a few notches with big beats, then you've found the right subwoofer. Boasting a 3" voice coil, 170 oz magnet, and 800 watts RMS, this powerful music-maker is built for performance on any budget. Its 1600 Max power level is designed to make no less than Zeus himself tremble with admiration at your sound system's strength. Unleash the power of American Bass Titan's thunderous low-end sound - upgrade and save today!

American Bass 10" Subwoofer TITAN 1044 Dual 4 Ohm American Bass has designed a subwoofer with a white powder finish heavy-duty stamped basket for better voice coil cooling and performance. The design of the American Bass TITAN 1044 subwoofer offers a multilayer high-density foam surround, flat T-yoke with hi-extend pole price, and multiple CONEX spiders. Specifically designed with a cooling motor for ultimate power handling and gut-wrenching bottom end bass that will make your system stand out from the rest.

Also Known As: TITAN1044 / TITAN10D4 / TITAN-10D4 / TITAN-10-D4

Subwoofer Details:

• MAX Power Handling: 1600W
• RMS Power Handing: 800W
• Impedance: DVC 4 Ohm
• Sensitivity: 84.2 dB
• Mounting Diameter: 8.98"
• Mounting Depth: 6.34"
• Weight: 22 lbs.
• 3.0" Diameter High-Temp 4-Layer Voice Coil
• Heavy-Duty White Powder Coated Stamped Steel Basket
• Kevlar Fiber Enforced Non-Pressed Paper Cone
• Red Stitched 3-Layer High Density Foam Surround
• Double Stacked 170oz. Magnet Assembly
• Perimeter Voice Coil Cooling Vent Design
• Chrome Spring Loaded Wire Terminals
• Durable Rubber Magnet Boot
• Recommended Ported Box Size: 1.25 - 1.5 Cubic Feet
• Owner's Manual / Spec Sheet

Amplifier Details:

• 1080W RMS X 1 @ 1 Ohm
• 790W RMS X 1 @ 2 Ohms
• 510W RMS X 1 @ 4 Ohms
• Frequency Response: 15Hz - 250Hz
• Linear Bandwidth: 15Hz to 250Hz +/- 3 dB
• Low Pass Crossover: 30Hz - 300Hz
• Supply Voltage: 9 - 16V
• Amplifier Efficiency: >80%
• Damping Factor: 200dB
• Signal to Noise Ratio: >90dB
• T.H.D. & Noise: 0.5%
• Phase Shift: 0 - 180
• Variable Bass Boost: 0-18dB
• Subsonic Filter: 10 - 25Hz
• Variable Input Level Control: 0.2V - 6.0V
• Fuse Rating: 100A External (not included)
• Positive Terminals: 1 x 4 AWG
• Negative Terminals: 1 x 4 AWG
• Remote Turn-On Signal: 12 AWG
• Speaker Output Terminals: 12 AWG
• Dimensions: 8.66" x 9.25" x 2.75"
• Weight (Approx.): 7.3 lbs.
• All MOSFET Power Supply & Output Stage
• Heavy Gauge / High Current Custom Power and Speaker Terminals
• 12dB Octave Low-Pass Filter
• Remote Gain Controller Included
• Electronic Crossover Network
• Bass Boost Circuit
• Power and Protection LED Indicators
• Soft Turn-on/Turn-off Turn-On Delay
• Fault and Protection Monitoring
• 4-Way Protection: Thermal, DC offset, Short Protection, Under & Over Voltage

Shop For Wiring & Batteries

Shop For Subwoofer Boxes

Browse Custom Box Builders

Please feel free to send us a message if you have any questions about this package.