American Bass XO 10 V2 Package | 10" 600W D4 Subwoofer & Orion CBA2000.1D Amplifier

Sub & Amp Package Deal

(1) American Bass XO 10 Inch 600W DVC 4 Ohm Subwoofer | XO1044 V2

(1) Orion Cobalt CBA2000.1D | 2000W Max Monoblock Subwoofer Amplifier

*This setup is intended to run at 2 Ohms

If you’re an audiophile looking to upgrade your sound system, look no further than the American Bass XO series subwoofers. These all-around speakers are a classic American Bass design, proven time and time again to bring superior sound into your home or car audio setup. With incredibly low prices and unbeatable performance, there’s nothing else like it for taking your music experience to the next level. The XO series was designed with dual voice-coils for a deep and powerful bass response that won’t break the bank - compared to other similar subs in its class, this is a great value without sacrificing any sound quality. Make sure to check out the American Bass XO Series V2 Subwoofers before tuning up your system - you won’t be disappointed!

Also Known As: XO-1044 / XO10D4 / XO10-D4 / XO-10D4 / XO-10-D4 / XO1044-V2 / XO-1044-V2

Subwoofer Details:

• MAX Power Handling: 600W
• RMS Power Handing: 300W
• Impedance: DVC 4 Ohm
• Frequency Range: 30-500Hz
• Sensitivity: 83.8 dB
• Mounting Diameter: 9.24"
• Mounting Depth: 5.52"
• Weight: 14 lbs.
• 2.0" Diameter High-Temp Voice Coil
• Stamped Steel Basket w/ Black Powder Coat
• Rigid Non-Pressed Paper Cone
• Oversized Double Stitched Rubber Surround
• 90oz. High-Energy Magnet Structure
• Rubber Gasket & Magnet Boot
• Chrome Push Terminals
• Recommended Ported Box Size: 1.25 Cubic Feet
• Owner's Manual / Spec Sheet

Amplifier Details:

• 2000W Peak Rating
• 500W RMS X 1 @ 1 Ohm
• 260W RMS X 1 @ 2 Ohms
• 160W RMS X 1 @ 4 Ohms
• Frequency Response: 10Hz - 250Hz
• Subsonic Filter: 15 - 50Hz
• Low Pass Crossover Continuously Variable: 40 - 250Hz
• Supply Voltage: 10 - 16V
• Input Impedance: 22 KOhm
• Signal to Noise Ratio: >90 dB
• Phase Shift: 0/180 Degrees
• Variable Bass Boost: 0 - 12 dB
• Variable Input Level Control: 0.2V - 6.0V
• Fuse Rating: 60A (2 x 30A ATC)
• Positive Terminals: 1 x 4 AWG
• Negative Terminals: 1 x 4 AWG
• Remote Turn-On Signal: 10 AWG
• Speaker Output Terminals: 10 AWG
• Dimensions: 9.92" x 7.09" x 2.13"
• Weight (Approx.): 4 lbs.
• All MOSFET Power Supply & Output Stage
• Heavy Gauge / High Current Custom Power and Speaker Terminals
• 1-Ohm Stable
• Remote Gain Controller Included
• RCA Out Throughput
• 12dB Octave Low-Pass Filter
• Electronic Crossover Network
• Bass Boost Circuit
• Intelligent Power and Protection LED Indicator
• Soft Turn-on/Turn-off
• Turn-On Delay
• Fault and Protection Monitoring
• 4-Way Protection: Thermal, DC offset, Short Protection, Under & Over Voltage

Shop For Wiring & Batteries

Shop for Subwoofer Boxes

Browse Custom Box Builders

Please feel free to send us a message if you have any questions about this item.