American Bass ELITE 15 Package | Dual 15" 2400W D4 Subwoofers & Orion XTR2500.1DZ Amplifier

Sub & Amp Package Deal

(2) American Bass ELITE 15 Inch 2400W DVC 4 Ohm Subwoofers | E1544

(1) Orion XTR 2500W RMS Monoblock Subwoofer Amplifier | XTR2500.1DZ

*This setup is intended to run at 1 Ohm

Looking to get the power of an XFL subwoofer without breaking the bank? You’re in luck! American Bass Elite Series subs pack a mighty punch and are close in performance to the XFL - except these bad boys don't come with a hefty price tag. Packing a whopping 150oz stacked magnet for maximum efficiency, plus a fiber-added non-pressed cone and hi-roll high-density foam surround with double stitching, you can ensure your sound is pumping at all times. American Bass doesn't mess around - each sub woofer has a 3” hi-temp 4-layer voice coil on an aluminum bobbin for up to 2400 Watts Max of power handling. Don't suffer through dull, flat music any longer - get an American Bass Elite Series subwoofer and feel like royalty with audio perfection.

Also Known As: ELITE1544 / ELITE-1544 / ELITE15D4 / ELITE-15D4 / ELITE-15-D4 / E-1544 / E-15D4

Sub Details (each):

• MAX Power Handling: 2400W
• RMS Power Handling: 1200W
• Impedance: DVC 4 Ohm
• Sensitivity: 87.3 dB
• Mounting Diameter: 13.5"
• Mounting Depth: 7.71”
• Weight: 31 lbs.
• 3.0" Hi-Temp 4-Layer Flat Aluminum Voice Coil on Aluminum Bobbin
• Heavy Durable Stamped Basket w/ Black Powder Finish
• Fiber Added Non-Press Paper Cone
• Hi-Roll High-Density Foam Surround w/ Silver Stitching
• Double Black Poly-Cotton Spider
• Double Thick Tensile Stitched On Spider
• Double Stacked 75oz. High Grade Magnets
• 1-Piece Tech Deep Bumped T-Yoke For Maximum Excursion
• Chrome Push Terminals
• Custom Tooled Rubber Gasket
• Rubber Magnet Boot To Protect Motor
• Recommended Ported Box Size: 3.25 Cubic Feet
• Owner's Manual / Spec Sheet

Amplifier Details:

• 2500W RMS X 1 @ 1 Ohm
• 1750W RMS X 1 @ 2 Ohms
• 1250W RMS X 1 @ 4 Ohms
• Frequency Response: 20Hz - 250Hz
• Low Pass Crossover: 30Hz - 300Hz
• Supply Voltage: 9 - 16V
• Amplifier Efficiency: >88%
• Damping Factor: 200dB
• Signal to Noise Ratio: >90dB
• T.H.D. & Noise: 0.5%
• Phase Shift: 0 - 180
• Variable Bass Boost: 0-18dB
• Subsonic Filter: Off / 25Hz
• Variable Input Level Control: 0.2V - 6.0V
• Fuses Rating: 250A External (not included)
• Positive Terminals: 1 x 0 AWG
• Negative Terminals: 1 x 0 AWG
• Remote Turn-On Signal: 10 AWG
• Speaker Output Terminals: 4 AWG
• Dimensions: 14.17" x 9.25" x 2.75"
• Weight (Approx.): 12.65 lbs.
• All MOSFET Power Supply & Output Stage
• Heavy Gauge / High Current Custom Power and Speaker Terminals
• 12dB Octave Low-Pass Filter
• Remote Gain Controller Included
• Electronic Crossover Network
• Bass Boost Circuit
• Power and Protection LED Indicators
• Soft Turn-on/Turn-off Turn-On Delay
• Fault and Protection Monitoring
• 4-Way Protection: Thermal, DC offset, Short Protection, Under & Over Voltage

Shop For Wiring & Batteries

Shop For Subwoofer Boxes

Browse Custom Box Builders

Please feel free to send us a message if you have any questions about this package.