American Bass XR 10 Package | 10" 2000W D2 Subwoofer & Orion XTR1000.1D Amplifier

Sub & Amp Package Deal

(1) American Bass XR 10 Inch 2000W DVC 2 Ohm Subwoofer | XR10D2

(1) Orion XTR 1000W RMS Monoblock Subwoofer Amplifier | XTR1000.1D

*This setup is intended to run at 1 Ohm

Get ready to experience a whole new level of bass with American Bass’ XR Series Subwoofer! If you’re serious about sound, this is the way to go. Unlike other subwoofers, The XR is equipped with newly re-designed terminals that have been conveniently positioned on one side, making installation faster and easier than ever. Just plug it in, turn up the volume and get ready to shake the ground beneath your feet! 

The XR Series Subwoofer has no equal with its fiberglass reinforced cone, cast frame and stitched rubber surround. No matter what type of music you love, you can be sure that every note will be heard loud and clear for an unforgettable listening experience. So don’t wait any longer – get American Bass’ XR Series Subwoofer now for mind-blowing sound quality and bass so low you can feel it in your gut!

Also Known As: XR-10D2 / XR-10-D2 / XR10-D2 / XR1022 / XR-1022

Subwoofer Details:

• MAX Power Handling: 2000W
• RMS Power Handing: 1000W
• Impedance: DVC 2 Ohm
• Sensitivity: 88 dB
• Mounting Diameter: 9.2"
• Mounting Depth: 7.08"
• Weight: 30 lbs.
• 3.0" Diameter High-Temp 4-Layer Voice Coil
• 200oz. Double Stacked Magnet Structure
• Black Power Coated Diecast Aluminum Basket
• Stitched Rubber Surround
• Woven Fiberglass Reinforced Cone
• PVC Gasket Ring & Magnet Boot
• Chrome Push Terminals
• Recommended Ported Box Size: 1.25 - 1.5 Cubic Feet
• Owner's Manual / Spec Sheet

Amplifier Details:

• 1080W RMS X 1 @ 1 Ohm
• 790W RMS X 1 @ 2 Ohms
• 510W RMS X 1 @ 4 Ohms
• Frequency Response: 15Hz - 250Hz
• Linear Bandwidth: 15Hz to 250Hz +/- 3 dB
• Low Pass Crossover: 30Hz - 300Hz
• Supply Voltage: 9 - 16V
• Amplifier Efficiency: >80%
• Damping Factor: 200dB
• Signal to Noise Ratio: >90dB
• T.H.D. & Noise: 0.5%
• Phase Shift: 0 - 180
• Variable Bass Boost: 0-18dB
• Subsonic Filter: 10 - 25Hz
• Variable Input Level Control: 0.2V - 6.0V
• Fuse Rating: 100A External (not included)
• Positive Terminals: 1 x 4 AWG
• Negative Terminals: 1 x 4 AWG
• Remote Turn-On Signal: 12 AWG
• Speaker Output Terminals: 12 AWG
• Dimensions: 8.66" x 9.25" x 2.75"
• Weight (Approx.): 7.3 lbs.
• All MOSFET Power Supply & Output Stage
• Heavy Gauge / High Current Custom Power and Speaker Terminals
• 12dB Octave Low-Pass Filter
• Remote Gain Controller Included
• Electronic Crossover Network
• Bass Boost Circuit
• Power and Protection LED Indicators
• Soft Turn-on/Turn-off Turn-On Delay
• Fault and Protection Monitoring
• 4-Way Protection: Thermal, DC offset, Short Protection, Under & Over Voltage

Shop For Wiring & Batteries

Shop for Subwoofer Boxes

Browse Custom Box Builders

Please feel free to send us a message if you have any questions about this package.